Diameter Of The Loop On Each End Of The Redline 8 inch Lanyard Part # 2608
Question:
Could you tell me what the diameter of the loops is? On a BigTex trailer the lanyard is held in place on one end by a 5/8ths inch bolt so a small loop will not work. Thanks
asked by: John M
Expert Reply:
The 8" Long Lanyard # 2608 has two loops, one on each side. The loops measure 1/2 inch long 1/4 inch wide. Go to your local hardware store and grab a bolt/self tapping screw that the threaded portion falls within the dimensions of the loop. The head of the bolt/screw should be bigger than the loop just to prevent it from slipping off. You want to have the majority if not all the loop underneath the head of the hardware you use.
If you want to learn more about the Lanyard, I've included a video with more info!
Product Page this Question was Asked From
Continue Researching
- Q&A: Coupler Lock Recommendation for UFP A-60 Brake Actuator
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: How Much Ground Clearance Do You Lose With the B&W Tow & Stow BWTS10048B
- Q&A: Is etrailer.com Logo Visible on Trailer Hitch
- Q&A: Does etrailer Sticker Come Off of Gustafson RV Wall Sconce 277-000265
- Q&A: How Does Buyers Products Pin with Lanyard # 3373006875 Fasten to Trailer?
- Q&A: Retracted Height Dimension of the Bulldog Jack part # BD190708
- Q&A: Standard Grease/Dust Caps Won't Fit Hubs on Trailstar Boat Trailer
- Article: Trailer Wiring Diagrams
- Article: Determining Trailer Tongue Weight
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure for Trailer Hitch Drop
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft