Correcting Slight Under Adjusted Husky Centerline Weight Distribution System
Question:
how to correct slight under adjusted Husky Centerline
asked by: Steve
Expert Reply:
The Husky Center Line Weight Distribution w/ Sway Control - Trunnion - 8,000 lbs GTW, 800 lbs TW # HT32217 if under adjusted will need to have the spring bar brackets lifted. I've attached the installation instructions that include the diagrams as well as the following steps:
Removing the spring bar from the lift bracket
25.Make sure the tow vehicle and the trailer are on level ground and are straight. Chock the trailer
wheels, and engage the emergency brake on the tow vehicle.
26.Raise the trailer tongue sufficient to ease the force required to lift the spring bar ends off of the lift brackets. Place the lift tool on the round peg on the forward side of the lift bracket and under the end of the spring bar as shown. And start pushing down on the lift tool.
27.Continue pushing down on the lift tool until it starts to come up and towards you. IMPORTANT: Do not be in a rush here, stay in control of the tool.
28.There will be a point where the spring bar will stop and come to a rest on top of the 2 round pins on the lift bracket. Stop there and keep your hands away from the spring bar.
29.Remove the lift tool from under the spring bar and position it as shown below. Place the tip of the tool against the side of the frame, somewhere on the frame bracket or even on the lift bracket is fine. Then pull out on the handle (keeping hands away from the spring bar) until the spring bar falls off the lift bracket completely.
