How To Confirm Fit of Draw-Tite Ultra Frame Service Body Trailer Hitch Receiver
Question:
HI I need a hitch for a Freightliner XCS chassis and as long as this can fit I dont mind welding. is there a way to know if this can fit besides with of frame? Thanks
asked by: Mark H
1
Helpful Expert Reply:
The Draw-Tite Ultra Frame Service Body Trailer Hitch Receiver part # 41990-07 will work on pretty much any motorhome chassis so long as the chassis does not exceed 44" in width from the outside of each frame rail. It can be attached via either drilling or welding.
expert reply by:
Conner L
1
Product Page this Question was Asked From
Draw-Tite Ultra Frame Service Body Trailer Hitch Receiver - Weld On - Class V - 2"
- Heavy Duty Receiver Hitch
- Weld-On
- 44 Inch Wide
- 1600 lbs TW
- 16000 lbs GTW
- Class V
- 2 Inch Hitch
- 7 Inch Drop
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Trailer Hitch Recommendation for an International 4300
- Q&A: Recommended Class V Hitch For A 2020 Ford F53 Chassis
- Q&A: Universal Hitch to Install on a Class A RV Rated for 10,000 Pounds
- Q&A: Recommended Trailer Hitch for an International 3800 School Bus
- Q&A: Trailer Hitch for 2010 IC Bus CE-Series
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Recommended Trailer Hitch For 2014 GMC Savana Cutaway Chassis
- Article: What is Boondocking
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Flat Towing Package for 2007-2018 JK Jeep Wrangler and Wrangler Unlimited
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: How to Measure for Trailer Hitch Drop