Can Kodiak Disc Brake Kit K2HR2D be Used with 1,500 PSI Rated Tie Down Actuator
Question:
Will a Tiedown 660E Disc Brake Actuator produce enough psi it says it needs 1500 to work.
asked by: Dan C
1
Helpful Expert Reply:
Yes the Kodiak disc brake kit part # K2HR2D will work with your actuator as it has a minimum psi rating of 1,500 lbs like what you have.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Kodiak Disc Brake Kit - 8" Rotor/Hub - 5 on 4-1/2 - Dacromet - 2,000 lbs
- Accessories and Parts
- Trailer Brakes
- Disc Brakes
- LH
- RH
- 2000 lbs
- Brake Assembly
- 5 on 4-1/2
- Hub and Rotor Assembly
- Kodiak
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Trailer Light Fuse Locations On A 2015 Ford F-250 Super Duty
- Q&A: Installing 7-Way Trailer Connector on 2005 Ford E-150 Van
- Q&A: Troubleshooting Trailer Lights Remaining On After 2020 Chevrolet Silverado 1500 is Shut Off
- Q&A: Replacement Rotor With Hub For 2008 Tahoe Boat Trailer Q5SA
- Q&A: Replacement Trailer Wheel Hubs for 2005 Tahoe Boat Trailer
- Q&A: How To Confirm Fit of Kodiak Disc Brake Kit
- Q&A: Are Trailer Spring Seats Needed for Square Axles with Leaf Springs?
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Brake Controller Installation: Starting from Scratch
- Article: Where to Position the Trailer Axle?
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer
- Article: Trailer Wiring Diagrams