Where To Drill Hole in Bed of 2010 Ford F-150 Short Bed to Install B and W Turnoverball Gooseneck
Question:
What is the measurement to drill hole in bed of truck. 2010 F150 6 1/2’ bed
asked by: Ronnie B
1
Helpful Expert Reply:
You'll need to measure 45-1/8 inches forward from the rear truck bed edge of your 2010 Ford F-150 short bed forward to determine the location of where to drill when installing the # BWGNRK1104.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
B&W Turnoverball Underbed Gooseneck Trailer Hitch w/ Custom Installation Kit - 30,000 lbs
- Gooseneck Hitch
- Below the Bed
- Manual Ball Removal
- 7500 lbs TW
- 30000 lbs GTW
- Removable Ball - Stores in Hitch
- Wheel Well Release
- 2-5/16 Hitch Ball
- B and W
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Gooseneck Trailer Hitch Information and Review
- Q&A: How Do I Measure To Find The Center of the Hole For My B&W Turnoverball Gooseneck On 2014 F-150?
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: How to Tow 2020 Chevy Spark with Automatic Transmission Behind RV
- Q&A: Trailer Hitch to Mount On the Back of a Horse Trailer for a Cargo Carrier
- Q&A: Replacement Top Seal For Main Slide Out On My 2002 Damon Intruder 375
- Q&A: Trailer Tires to Replace 155R12 Tires
- Q&A: Do I Have to Have a Sliding 5th Wheel Hitch in a Short Bed Truck
- Q&A: What is Length Measurement of 7-Leaf Double-Eye Spring DX74XR
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Frequently Asked Questions About Transmission Coolers
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Trailer Maintenance Schedule
- Article: Stability Control for Heavy Duty Vehicles