Looking for 45mm Grease Cap
Question:
Looking for 45 mm grease dust cap. Am I going to have to figure out how to make a dust cap? I can not find one to fit my small hubs. I only need one but would purchase four if I could find them. I bought the bearings, why cant I find dust caps?
asked by: Daulton R
Helpful Expert Reply:
The grease cap you'll need for your 1.77 inch hub bore is from Fulton, part # F001503. The outside diameter at the base is 1.78 inches which is perfect, as it's meant to fit tightly. I've linked you to a product description video featuring the Fulton grease cap.
Products Referenced in This Question
Fulton Grease Cap - 1.786" Outer Diameter - 1-9/16" Tall - Drive In
- Trailer Bearings Races Seals Caps
- Caps
- Standard Grease Cap
- 1.781 Inch O.D.
- Fulton
more information >
Product Page this Question was Asked From
Grease Cap, 1.988" OD Drive In - Qty 2
- Trailer Bearings Races Seals Caps
- Caps
- Standard Grease Cap
- 1.98 Inch O.D.
- TruRyde
more information >
Continue Researching
- Shop: Trailer Wiring
- Search Results: 118871
- Shop: Grease Seal SL200
- Shop: Grease Seal 29031
- Search Results: jack
- Video: Best Trailer Brake Options
- Shop: Brake Controller
- Shop: Tailgate
- Shop: Truck Bed Tailgate Assist
- Q&A: Grease Seal Recommendation for Dimensions 1.375 ID and 1.983 OD
- Shop: T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: Kodiak 10" Hub-and-Rotor Assembly - 5 on 4-1/2 - Dacromet - 3,500 lbs
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: Autowbrake Electric Brake Controller - Trailer Mount w/ Remote Fob - 1 to 3 Axles - Proportional
- Shop: Curt Powered Tail Light Converter w/ 4-Way Flat Trailer Connector and Install Kit
- Search Results: latch
- Search Results: brake control harness
- Search Results: tk93vr
- Search Results: tilt latch
- Search Results: 19309
- Q&A: 5-Bolt Trailer Hub With Inner Bearing LM67048 & Outer Bearing LM11949
- Q&A: Recommended Hub for 3K Trailer Axle with 1.25" Inner and .75" Outer Bearing
- Q&A: Hub Recommendation for Spindle with Diameters of .75 and 1.25 inches
- Q&A: Replacement LM11949 Bearing and LM11910 Race Needed
- Q&A: Replacement Hubs Based on Tapered Spindle Measurements
- Q&A: Hub For Outer Bearing LM11949 & Inner Bearing LM67048
- Video: Bearing Buddy Trailer Bearings Races Seals Caps - Caps - BB1781SS Review
- Video: Bearing Buddy Trailer Bearings Races Seals Caps - Caps - BB1810 Review