Will Pro Series A-Frame Trailer Jack # PSRV20000103 Fit a Haulmark Trailer
Question:
Hello and thank you for the help. I have a Haulmark 5x10 trailer and need to replace the tongue jack. I dont know a whole lot about trailers and wanted to know whether this jack would fit in place of the original one. Im guessing the bolt locations are industry standard, but wanted to confirm and thought you might know. Appreciate the help.
asked by: Louis P
Expert Reply:
The bolt pattern to mount an A-frame jack is a standard and the Pro Series jack, # PSRV20000103, also has slotted holes to allow for some variations in the pattern so it should work fine for you. Make sure that your current jack has an outer tube diameter of 2-1/8 inches so the new jack will fit.
The Pro Series jack does not come with a foot or wheel. Your old foot might work if it fits around a 2 inch diameter lower tube. If you need a new foot use # PS1400700340. For a wheel use # PS1400750340.
This jack has a 2,000 pound capacity so if your trailer requires a higher capacity you will want to go with a different model.
Products Referenced in This Question
Pro Series Detachable Footplate w/ Pin for 2" Diameter Jacks - 2,000 lbs to 5,000 lbs
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Jack Foot
- 2 Inch Diameter Tubing
- Pro Series
more information >
Pro Series 6", Detachable Caster w/ Pin for 2" Diameter Jacks - 1,200 lbs
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Jack Wheel
- 6 Inch Wheel
- Wheel w Caster Assembly
- 2 Inch Diameter Tubing
- Pro Series
more information >
Product Page this Question was Asked From
Pro Series Round, A-Frame Jack w/ External Gearbox - Sidewind - 14" Lift - 2,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Sidewind Jack
- 14 Inch Lift
- Bolt-On
- Weld-On
- No Wheel or Foot
- Pro Series
more information >
Continue Researching
- Q&A: How to Tell If MORryde Rubber Equalizers Will Fit Trailer
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Correct Replacement for AL-KO 7230 Hub/Drum and Brakes
- Q&A: Is Bow in 3,500 lb Trailer Axle Enough Camber for Loaded and Unloaded Trailers
- Q&A: How to Wire a New 4-Way to a Sea Doo Trailer that Has Double Wires
- Q&A: One Inch Wide Trim For Horse Trailer
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Q&A: When to Replace Dexter Nev-R-Lube Bearings
- Article: Must Have RV Accessories that Will Make or Break Your Trip
- Q&A: Trailer Tire Size to Replace 8.75R16.5 Tires
- Article: Trailer Maintenance Schedule
- Article: Trailer Wiring Diagrams
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Gooseneck to 5th Wheel Adapters