What Size Bolt to Use with Rubber Bumper for Enclosed Trailer Ramp Door # 37210715
Question:
What screw is used to hold this bumper into place?
asked by: Wil P
0
Expert Reply:
The hole diameter of the Rubber Bumper for Enclosed Trailer Ramp Door # 37210715 is 3/8 inch so you'd want to pick a screw or bolt with that diameter to fit the best. We have a 3/8 inch diameter lag bolt with part # FA74521 which might work for your application.
expert reply by:
Jameson C
0
Products Referenced in This Question
Stainless Steel Hex Lag Screw - 3/8"
- Accessories and Parts
- Trailer Fenders
- Screws
- Flint Hill Goods
more information >
Product Page this Question was Asked From
Rubber Bumper for Enclosed Trailer Ramp Door - 2-1/2" Diameter
- Trailer Door Parts
- Ramp Door Bumpers
- Round Bumper
- 2-1/2 Inch Wide
- Rubber
- JR Products
more information >
Continue Researching
- Shop: Rubber Bumper for Enclosed Trailer Ramp Door - 2-1/2" Diameter
- Shop: Fulton Marine Jack - Weld On - Sidewind - 10" Lift - 1,200 lbs
- Search Results: fxp10w0301
- Search Results: trailer hitch
- Search Results: trailer parts
- Shop: Stainless Steel Hex Lag Screw - 3/8"
- Video: JR Products Enclosed Trailer Ramp Door Rubber Bumper Review
- Shop: Replacement Crank Handle for etrailer and Ram 5th Wheel Landing Gear
- Shop: Bauer Products Locking Cam Latch for Horse Trailers - Matte Black - AE Series Key
- Shop: Replacement Handle Assembly for Polar Cam-Action Latch Kits - Zinc-Plated Steel
- Search Results: ramp door bumpers
- Search Results: washer
- Shop: Replacement Black Door for 6-Gallon Atwood Water Heater
- Search Results: landing gear crank
- Search Results: ramp hinge
- Article: How to Install E-Track in 3 Easy Steps
- Video: Review of Marlboro Trailer Door Hinges - Barrel Hinge - MA34ZR
- Video: Polar Hardware Enclosed Trailer Parts 158-100 Review
- Video: Review of Polar Hardware Trailer Door Parts - Handle Assembly - PLR158-100-A
- Shop: RV Jack Pads
- Article: RV Propane 101: How Does My RV's Propane System Work?
- Shop: RV Exterior Lighting
- Q&A: Is There a Pad For Feet of Lippert Scissor Stabilizer Jacks
- Q&A: How to Choose Best Thickness for Ramp Door Seal Kit
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Idler Hub For Old Boat Trailer With DICO 45264 Idler Hubs
- Q&A: Replacing Bearing Seals on Older DICO Hub and Drum
- Q&A: Replacement Lug Stud for Dico Trailer Hub Assembly 45263
- Q&A: How to Calculate the Weight of the Ramp to Make Sure Door Spring is Correct
- Q&A: How To Lower Spring Tension of Gorilla Lift Tailgate Assist