How Does the Replacement Vacuum Pump for Dometic Toilets Connect On the Intake Side

Question

Question:

On the tank side of the vacuum generator intake side of pump p/n 385311595 does the white fitting just slide into the holding tank? It doesnt appear to be threaded. I do see two o-rings on your photo on that piece.

asked by: Sim L

0

Expert Reply:

That is correct. The intake pipe on the # DOM33FR is not threaded, but instead has two rubber gaskets to ensure a water tight seal on the pipe.

expert reply by: Erik B

0

Answer 1

The Replacement Vacuum Pump for Dometic VacuFlush RV Toilet - 12V #DOM33FR comes with everything that is pictured in the photos on the product page. I do believe you're referring to one of the connections for the pump that is threaded (shown in…

view full answer...

Answer 2

Yes, we have just what you were looking for. For the Pump Assembly only order the Dometic #DOM33FR. For the pump assembly and tank order Dometic #DOM46FR. Just click to add the parts you need to your online cart and at check out you will have several…

view full answer...

Answer 3

Yes, the Replacement Vacuum Pump for Dometic VacuFlush RV Toilet #DOM33FR does have the whisper motor.

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 7

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 10

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 11

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 12

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

How Does the Replacement Vacuum Pump for Dometic Toilets Connect On the Intake Side

Product Page this Question was Asked From

Continue Researching