What Type Of Flare Needs To Be Used with Replacement Master Cylinder for Titan Model 60
Question:
Hello, Can you tell me what type of flare is required for the connection at the back of this master cylinder double or bubble? I cant tell from the rusted end that broke off when i removed my old master cylinder. Can you also tell me what size fitting i need to connect to the brake line to the master cylinder? Thanks,
asked by: Greg L
Expert Reply:
The brake lines on a trailer should all be of the double flare type so that is what I recommend using with the brake actuator like one that uses the Replacement Master Cylinder Assembly for Titan Model 60 and Aero 7500 Brake Actuators part # T4395100. It should then use a 3/8" size flare fitting.
Product Page this Question was Asked From
Replacement Master Cylinder Assembly for Dexter Model 60 and Aero 7500 Brake Actuators - Drum
- Accessories and Parts
- Brake Actuator
- Hydraulic Drum Brakes
- Master Cylinder
- Dexter
more information >
Continue Researching
- Q&A: Replacement Master Cylinder For Titan Model 60 W/ 23361 Master Cylinder
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: Replacement Surge Brake Actuator For Atwood 85736 That Is Discontinued
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Q&A: Replacement Master Cylinder for DICO 189
- Q&A: Replacement Master Cylinder for Titan AERO 6000 Actuator
- Q&A: Replacement Master Cylinder for Titan 60ZX7000 Drum Brake Actuator
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: Replacement Actuator for an Older Atwood 85736
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Tire TLC: How & When to Check Your RV/Trailer Tire Pressure
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Trailer Wiring Diagrams
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer