Distance from Upright Mast of Brophy Camper Jack to Bracket that Holds Camper
Question:
The camper shell is flush with the top of the truck bed. The wheel wells on the truck flare approximately 3-4 inches. How far does the supporting plate extend so that it will go under the camper shell so that the shell can be safely removed. The truck is standard Silverado 1500 and does not have an abnormal flare on the wheel wells. Thanks
asked by: Gary A
1
Helpful Expert Reply:
I checked with Brophy and the Brophy Camper Jacks # CJ31 have a distance of 3 inches from the upright mast to backside of the bracket that would hold your camper shell.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Brophy Cable Camper Jacks - 57" Max Lift Height - 1,000 lbs - Qty 2
- Camper Jacks
- Truck Camper
- Stabilizer Jacks
- Steel
- 1001 - 2000 lbs
- Sidewind Jack
- 57 Inch Lift
- 2 Jacks
- Brophy
more information >
Continue Researching
- Article: How to Mount a Truck Bed Camper
- Q&A: How to Order a Quantity of 4 Camper Jacks
- Q&A: Solution for Truck Bed Camper Jacks with Bad Gears
- Q&A: Best Camper Tie Downs that Fit 2016 Toyota Tundra 6-1/2 ft Bed
- Q&A: Instructions For HappiJac Truck-Mounted Camper Tie-Downs # LC184089
- Q&A: Can Brophy Cable Camper Jacks # CJ31 Be Used to Stabilize Truck Camper
- Q&A: Homemade Slide In Camper Lift Recommendations
- Q&A: Can I Install Two Pairs Of Ark Stabilizer Jacks On A 6,000 lb Trailer?
- Article: Trailer Wiring Diagrams
- Article: Best Air Bag Suspension (2023)
- Article: How Much Solar Power Do I Need For My RV?
- Article: How to Choose the Right Trailer Hitch Class
- Article: Ram Trailer Tow Prep Package
- Article: Performance Chips and Modules