Tube Mount Diameter and Pin Size for Bulldog Swivel Trailer Jack # BD190705
Question:
BD190705 trailer jack need to know the inside diameter off the sleeve that is welded on to the trailer the one on my trailer is 2.5 inches inside dia with a pin dia of 7/8 of inch
asked by: Glen
0
Expert Reply:
I spoke with my contact at Bulldog and the inner diameter of the tube that gets welded to the trailer is 2-1/2 inches so the jack would fit the tube that is on your trailer. However, the pin diameter is 5/8 inches and not 7/8 inches. The 5/8 inch pin diameter is the common size and I was unable to find one with a 7/8 inch diameter pin.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Bulldog Square Swivel Jack w/ Round Pipe Mount - Fixed Leg - Topwind - 10" Lift - 5,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 4001 - 5000 lbs
- Swivel Jack
- Topwind Jack
- 10 Inch Lift
- Pipe Mount
- Weld-On
- With Rectangle Foot
- Bulldog
more information >
Continue Researching
- Q&A: Recommended Silver Trailer Wheels With a 6 on 5 1/2 Bolt Pattern
- Q&A: Is Demco SBS Coach Air Kit SM99627 The Same as Demco 6231
- Article: Tire TLC: How & When to Check Your RV/Trailer Tire Pressure
- Q&A: Can a 2014 Kia Soul With Manual Transmission be Flat Towed Behind an RV?
- Q&A: Should I Get a Proportional or Time-Delayed Brake Controller
- Q&A: Tow Bar Wiring For 2023 Jeep Grand Wagoneer
- Q&A: Bypassing Factory Brake Controller and Installing Aftermarket Model on 2018 GMC Sierra 3500
- Q&A: 5,000 lb Bulldog A-Frame Jack With Short Retracted Height
- Article: Best Boat Accessories
- Article: Trailer Wiring Diagrams