Replacement Nut and Screw for a Bulldog 10K or 12K Capacity Landing Gear Trailer Jack
Question:
I have a Bulldog 4inch square leg side wind landing gear style jack. I believe its 10,000/12,000# rated. The nut at the top of the jack that the screw runs in is worn out. Its 4inch square and slides into the outer tube secured by 2, 1/2inch pins. It appears to be gray cast iron. Can this nut be purchased?
asked by: Brent H
Expert Reply:
The nut by itself is not available as a separate part but we do have the screw and nut assembly, # BD500250. It is designed just like you have said with the 2 roll pins and is rated for 10K lift and 12K static load.
We also have # BD500217. It is designed to fit Bulldog series 182 jacks from 2003 to present, with 12K capacity.
Product Page this Question was Asked From
Bulldog Square Jack - Fixed Leg - Sidewind - 12-1/2" Lift - 10,000 lbs
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Alloy Steel
- 9001 - 10000 lbs
- Landing Gear
- Sidewind Jack
- 12-1/2 Inch Lift
- Weld-On
- 1 Jack
- Bulldog
more information >
Continue Researching
- Shop: Replacement Rod and Nut for etrailer and Ram Square, Direct Weld Jacks - 12K
- Shop: Square Direct Weld Jack - Drop Leg w/ Spring Return - Sidewind - 25-7/8" Lift - 10K
- Search Results: bd500217
- Search Results: 10000 lb trailer jack
- Q&A: Option For Replacing A Bulldog 182513 Square Jack
- Q&A: Adding an Electric Motor to Bulldog Square Jack # BD182701
- Q&A: Recommended 2-Speed Tandem Jack Setup with 12000-lbs Capacity
- Q&A: Square Trailer Jack Compatiblility With Electric Motor Kit
- Q&A: Replacement Parts for Bulldog Square Jack
- Q&A: Recommended Rebuild Gear Kit for Bulldog Jack
- Q&A: Bathroom Exhaust Fan With a Light for RV
- Article: Trailer Wiring Diagrams