Is Factory Hardware Reused when Installing Westin E-Series Tube Steps on a 2005 Chevy Colorado  

Question:

Expert Reply:

You will retain the factory bolt and bushing when installing Westin tube steps, # 23-3155. I have included a text version of the installation instructions for you to view.

1. Remove all contents from box. Verify all parts are present and free from damage. Read instructions carefully and understand before attempting installation
2. On the drivers side of the vehicle, remove the front body mount bolt from underneath the vehicle. Once removed drive the bolt out of the factory bushing save both the
bushing and bolt.
3. Take the drivers side mounting bracket and bolt it onto the vehicle using the factory bolt from the above step. The bracket will mount over the bushing. Do not tighten fully
at this time.
4. Take the drivers side front support bracket and insert (1) 12MM X 120MM hex bolt and , (1) 12MM flat washer through the mounting slot. Place (2) M14 flat washers onto the M12 hex bolt between the support bracket and the factory body mount. Insert the M12 hex head bolt up through the holes in the factory body mount and fasten with (1) M12 lock washer and, (1) M12 hex nut. Do not tighten fully at this time.
5. Locate the rear mounting brackets and mount them to the vehicle using the factory body mount bolts. The bracket will mount over the bushing. Refer to step 3.
6. Position the drivers sidebar up to the mounting brackets and align with the mounting holes. Attach with (2) 1/2 inch X 2 inch hex head bolts, (2) 1/2 inch lock washers and, (2) 1/2 inch flat washers. Do not fully tighten at this time.
7. Adjust sidebar properly then tighten all hardware at this time.
8. Repeat steps 2-8 for the passenger side.

expert reply by: Michael H

0