Troubleshooting RV Water Level Sensor Not Showing Full
Question:
I have installed Horst Sensors on my black tank. They had worked perfectly . now I have cleaned the tank thoroughly and filled it as full as possible. All three lights come on except the full light refuses to light. I have cleaned the contacts on the top sensor. It still will not light. What am I missing?
asked by: Leonard S
0
Expert Reply:
You might have disturbed the wiring of the sensors when you cleaned them. When the sensor is grounded it will show the reading so if you ground your highest "full" sensor and it show that it's working that would mean you have a wiring issue with it.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Horst Miracle Probe Sensors for RV Black Water Tanks - Qty 4
- Smart RV
- Monitoring System
- Water Tanks
- No Display
- Valterra
more information >
Continue Researching
- Q&A: What is Difference Between Furrion and Voyager Observation Pre-Wiring
- Q&A: Wiring An Atwood RV Water Heater With Double-Panel On/Off Switch
- Q&A: Replacement Remote For a HappiJac Electric Camper Jack System
- Q&A: Wiring Replacement 7-Way Connector on 2004 GMC Yukon Denali
- Q&A: When Should Trailer Wheel Bearings be Replaced
- Q&A: Replacing Black Water Tank Sensors
- Q&A: Recommended Roof Coating For EPDM Roof Membranes
- Article: Trailer Wiring Diagrams
- Article: Ram Trailer Tow Prep Package
- Article: Flat Towing Package for 2015 Ram 1500
- Article: Trailer Maintenance Schedule
- Article: Determining Trailer Tongue Weight
- Article: How Much Solar Power Do I Need For My RV?
- Article: Which RV Propane Tank Size Do I Need?