Disconnecting the Brake Cable from the Invisibrake Cylinder.
Question:
How do you disconnect the Invisibrake cylinder from the brake cable. The two pieces unscrew but it seems the inner shaft is still attached.
asked by: Greg Y
0
Expert Reply:
The inner shaft on the cylinder for Roadmaster Invisibrake is connected to the cable as well as the cylinder you have loose now. You will hold the inner shaft while loosening the very end of the assembly. It will likely be the case where you should first loosen the cable on the very end then the entire cylinder to get the assembly apart.
expert reply by:
Randy B
0
Product Page this Question was Asked From
Replacement Cable for Roadmaster InvisiBrake Flat Tow Brake System
- Accessories and Parts
- Tow Bar Braking Systems
- Cables
- Roadmaster
more information >
Continue Researching
- Q&A: Is A Check Valve Needed To Install The Roadmaster Invisibrake Second Vehicle Kit In A 2020 Ranger
- Q&A: Is There Install Video for Roadmaster Invisi Brake on 2019 Ford Ranger
- Q&A: Using The RoadMaster InvisBrake Second Vehicle Kit To Install On New Vehicle
- Q&A: Replacement Invisibrake Cable Recommendation
- Q&A: Roadmaster InvisiBrake Battery Charging Capabilities While Flat Towing
- Q&A: Replacement InvisiBrake Installation Kit For 2019 Jeep Cherokee
- Q&A: Recommended Tow-Bar Wiring Harness For 2014 Jeep Wrangler
- Article: Trailer Wiring Diagrams
- Article: Flat Towing Package for 2018 Jeep Wrangler JL and JL Unlimited
- Article: What Is a Supplemental Braking System?
- Article: Flat Towing Package for 2015-2018 Chevrolet Colorado and GMC Canyon
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Diode Installation Instructions for a Dinghy with Separate Tail Light Wiring
- Article: Roadmaster Vehicle Specific Base Plates