How to Safely Lift Landing Gear Legs on 2020 Cedar Creek 38FBD 5th Wheel to Swap Out Supports
Question:
I need to retract the front jacks one at a time about 4 inches to put concrete blocks under for support the support I have cracked how can I safely do this without hurting the rv thanks in advance 2020 cedar creek 38fbd 5th wheel
asked by: Lloyd S
Helpful Expert Reply:
The best way to swap out the supports under the landing gear legs from the Lippert Ground Control 3.0 # LC358590 on your 2020 Cedar Creek 38FBD 5th wheel is to hitch the RV to your tow vehicle and then retract the landing gear with the controller.
Aside from that I'm not sure what else would work unless you had an entire lift system that can handle the front end weight of your RV.
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 4 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Wiring Diagram and Fuse Location for the Lippert Ground Control 3.0 4-Point Leveling System
- Q&A: Wiring Installation for 5th Wheel Landing Gear Switch
- Q&A: Wiring Diagram for 5th Wheel Trailer Landing Gear with Red, Black, White, and Green Wires
- Q&A: Wiring Guide for Installing 5th Wheel Landing Gear Motor Switch
- Q&A: Which Lippert Ground Control 3.0 System Is Recommended for a 37' Fifth Wheel
- Q&A: Drawing Schematic of Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0
- Article: How to Raise Your Travel Trailer Height
- Q&A: Dimensions of Lippert Ground Control 3.0 Jacks For Clearance on Keystone Cougar 28SGS
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Trailer Wiring Diagrams
- Article: How to Level Your Fifth Wheel in 3 Simple Steps (Manual or Auto-Level)
- Article: Gooseneck to 5th Wheel Adapters
- Article: Double-Eye Trailer Suspension System Review
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)