Can Low Profile LED Flood Light # 3371492135 Wire Directly to Reverse Light Circuit
Question:
can these be just wired up to existing backup lights by splicing in to wire with out a problem?
asked by: Chuck
1
Helpful Expert Reply:
Yes, you can splice the Low Profile LED Flood Light # 3371492135 to your vehicle reverse lights. These only draw 1.5 amps so it wouldn't be an excessive drain on your light circuit.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Low Profile LED Flood Light - 1,620 Lumens - Black Aluminum - Clear Lens - 12V/24V
- Work Lights
- Flood Lights
- Work Lights
- Exterior Lights
- Rectangle
- Pedestal Mount
- Flood Beam
- LED Light
- White
- Buyers Products
more information >
Continue Researching
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Article: Trailer Tire Sizing
- Q&A: How to Cut a Grommet Hole for Installation of the Oval Trailer Tail Lights # STL22RB
- Q&A: Amp Draw Of Buyers Ultra Bright LED Flood Light
- Q&A: Does The AC Distribution Panel Of The PD4135K Power Center Need To Be Ground To The RV Chassis
- Q&A: What Gauge Wire Is Required On a 7-Way Connector
- Q&A: Troubleshooting Factory Trailer Wiring that has No Power
- Q&A: Replacing a SPB72-1621LD Pin Box with a Rota-Flex or a MORryde Pin Box with Chucking in Mind
- Q&A: Upgrading 19' Dometic Sunchaser Manual Awning To a Powered Awning Without Running 12 Volt Power
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Gooseneck to 5th Wheel Adapters
Chuck
5/7/2020
Thank you for getting back to me exactly what I wanted to know they will only be on when backing up just didn't want to melt anything