Trailer Bearing with Inner Diameter 1/4 inch Larger than L44649
Question:
II have a L44649 outer bearing D. I have a NAT 474276 oil seal B. I need an inner bearing C the ID of the bearing should be 1/4 inch more than the L44649.
asked by: Chris B
0
Products Referenced in This Question
Replacement Trailer Hub Bearing - 2585
- Trailer Bearings Races Seals Caps
- Bearings
- Standard Bearings
- 1.313 Inch I.D.
- Bearing 2585
- Race 2520
- 9000 lbs Axle
- etrailer
more information >
Product Page this Question was Asked From
Replacement Trailer Hub Bearing - L44649
- Trailer Bearings Races Seals Caps
- Bearings
- Standard Bearings
- 1.063 Inch I.D.
- Bearing L44649
- Race L44610
- 3500 lbs Axle
- etrailer
more information >
Continue Researching
- Article: Most Popular Wheel Bearings
- Article: Top Gifts for Dads in 2024
- Q&A: Should the Tires Lift Off the Ground While Leveling With the Lippert Ground Control Leveling System
- Q&A: How To Tell If Bearing Buddy Has Enough Grease
- Q&A: Can Bearing Buddy Bearing Protectors Be Over-Filled with Too Much Grease
- Q&A: Weight Capacity Of Lippert Spare Tire Winch For Over sized Tire
- Q&A: Inside Diameter of Replacement Crank Extension for Lippert Spare Tire Winch Assemblies
- Q&A: How Does Lippert Components Spare Tire Winch with Offset Cable Crank Up and Down
- Q&A: Does Lippert Spare Tire Winch Lock or Hold in Any Position?
- Article: How to Rent an RV
- Article: How to Measure a Trailer Axle
- Article: Trailer Maintenance Schedule
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer