Does the LED Backup Light w/ Flange for Trucks or Trailers Need To Be Replaced If Water Gets Inside
Question:
I have water inside one of these BUL11CBX, do I need to be concerned or just wait until it fails before I replace it. Thanks in advance.
asked by: Rodney T
0
Expert Reply:
If you have water inside the LED Backup Light w/ Flange for Trucks or Trailers part # BUL11CBX then that means the seal is broken. I recommend replacing this light as not only will it affect the luminosity of the light but it is very likely to cause a short on your trailer wiring harness. The seal can be broken by tightening the screws which hold the light too tight or just wearing out over time.
expert reply by:
Conner L
0
Product Page this Question was Asked From
LED Backup Light w/ Flange for Trucks or Trailers - Submersible - 10 Diodes - Round - Clear Lens
- Trailer Lights
- Tail Lights
- Backup
- Rear Reflector
- Round
- Recessed Mount
- Submersible Lights
- LED Light
- 5-3/4 Inch Diameter
- White
- Optronics
more information >
Continue Researching
- Shop: Vehicle Sway Bars
- Article: Performance Chips and Modules
- Search Results: extend a stay
- Q&A: Replacement Reverse Light for Ranger z521 Boat Trailer
- Q&A: Is The BAKFlip F1 Hard Tonneau Cover # BAK72331 Easily Removable From a 2022 Ford F-350 Long Bed?
- Q&A: Installing Trailer Tail Lights with Two Wire Connections on 4-Way Wiring
- Q&A: Dimensions of the Mounting Holes of the LED Trailer Stop/Turn/Tail Light # STL43RBX
- Q&A: Installation of LED Utility Light 3 Inch Round
- Q&A: Is Additional Components Needed with HydraStar Kit When Used with Two Vehicles
- Q&A: Does the LED Trailer Backup Light # BUL11CBX Require a 2 or 3-Prong Harness
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Article: Trailer Lighting Requirements
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Article: Trailer Tire Sizing