Inner Diameter of Bulldog Jack 190705
Question:
What is the inside diameter of the pipe welded to the jack? I already a mount on my trailer but it is designed for the jack to go over it and not inside. Thanks.
asked by: Barry D
0
Expert Reply:
The Bulldog Square Swivel Jack w/ Round Pipe Mount - Fixed Leg - Topwind - 10" Lift - 5,000 lbs # BD190705 has the pipe with the interior dimension of 2 inches. Mounting in the way you state will give you an extremely long pin but it would still work.
expert reply by:
Jason S
0
Product Page this Question was Asked From
Bulldog Square Swivel Jack w/ Round Pipe Mount - Fixed Leg - Topwind - 10" Lift - 5,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 4001 - 5000 lbs
- Swivel Jack
- Topwind Jack
- 10 Inch Lift
- Pipe Mount
- Weld-On
- With Rectangle Foot
- Bulldog
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Recommended Silver Trailer Wheels With a 6 on 5 1/2 Bolt Pattern
- Q&A: Is Demco SBS Coach Air Kit SM99627 The Same as Demco 6231
- Article: Tire TLC: How & When to Check Your RV/Trailer Tire Pressure
- Q&A: Can a 2014 Kia Soul With Manual Transmission be Flat Towed Behind an RV?
- Q&A: Should I Get a Proportional or Time-Delayed Brake Controller
- Q&A: Tow Bar Wiring For 2023 Jeep Grand Wagoneer
- Q&A: Bypassing Factory Brake Controller and Installing Aftermarket Model on 2018 GMC Sierra 3500
- Q&A: Dimensions Of Replacement Mounting Bracket For Trailer Valet
- Article: Best Boat Accessories
- Article: Trailer Wiring Diagrams