2010 Jayco Fifth Wheel Landing Gear Troubleshooting
Question:
I put a new landing gear motor on and the landing gear legs still won’t operate seems like it’s on a bind I try to operate manually with wrench but still won’t turni think it’s in the legs
asked by: Chuck M
Expert Reply:
It sounds very much like you have a bad gear box like the Aluminum Gearbox for Stromberg Carlson Landing Gear part # LG-179015. Which is designed for Stromberg Carlson landing gear.
To confirm this remove the motor then the old gearbox. Try at this point to operate each of the legs individually. If they both operate it is the gearbox. If the gearbox turns okay but one leg won't travel then it is that particular leg binding.
I included a video I did of the gear box replacement for you to check out.
Products Referenced in This Question
Replacement Aluminum Gearbox for Stromberg Carlson Landing Gear
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Motor and Gear Parts
- Gearbox
- Stromberg Carlson
more information >
Product Page this Question was Asked From
Replacement Lead Leg for Stromberg Carlson Landing Gear - 33-1/2"
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Legs
- Driver Leg
- Stromberg Carlson
more information >
Continue Researching
- Q&A: Replacement Landing Gear for VMC900R
- Q&A: Replacement Jack Legs for Venture Landing Gear VMC900R
- Q&A: Replacement Leg for Lippert Ground Control 2.0 LC241846
- Q&A: Replacement Landing Gear Legs for a 2010 Jayco Eagle Super Lite
- Q&A: Correct Replacement for Kwikee Step Motor 369545
- Q&A: How to Determine Correct Replacement Lead Leg for Landing Gear
- Q&A: Landing Gear Repair Kit Recommendation for a VMC900R Set
- Article: Best Landing Gear
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: RV Propane Troubleshooting | Common Propane Issues and How to Solve Them
- Article: Trailer Wiring Diagrams
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: How to Troubleshoot Your RV Air Conditioner
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)