Installation of AirLift 1000 Air Helper Springs on 2000 Toyota 4Runner Missing Jounce Springs
Question:
I notice these can be installed without a jounce bumper. The previous owner of my 2000 4runner removed the jounce bumpers completely and installed 2inch spacers above the coil springs. Am i correct in seeing that I can remove those spacers, install the puck that comes with this kit above the airbags, and that is it? Nothing else needs to go at the top of the spring? Thanks for your time
asked by: Tony
Helpful Expert Reply:
There are three different combinations of jounce bumpers for your 2000 Toyota 4Runner: no jounce bumper, small 3 inch jounce bumper or large jounce bumper (Fig.3). Installation of the AirLift 1000 # AL60743 depends on what style the vehicle had originally.
If there is a large hole at the top of the coil spring once the spacers are removed, you'll need to install the protector (puck) to cover that hole and install the airbag so the stem is facing up (Fig.5). If there is no large hole when you remove the spacers, you'll need to drill a 9/16 inch hole in the lower spring seat, then install the protector at the bottom of the coil spring and install the airbag so the stem is facing down, using the drilled hole to run your line out.
I've attached the complete step by step installation instructions for you at the bottom of this page as well.
Product Page this Question was Asked From
Air Lift 1000 Air Helper Springs for Coil Springs - Rear
- Vehicle Suspension
- Rear Axle Suspension Enhancement
- Air Springs
- Light Duty
- Air Lift
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Parts Needed to Add 7-Way and Brake Controller to 1999 Toyota 4Runner
- Article: What Do I Need To Tow A Trailer?
- Article: Tips on How To Tow a Trailer
- Article: How Much Trailer Can I Really Tow
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch
- Q&A: Recommended Hitch for a 2001 Toyota 4Runner w/ a Larger than Stock Tire
- Q&A: Availability of Hitch That Fits 2002 Toyota 4Runner With 270/70-R17 Spare Tire
- Q&A: Would the Draw Tite Hitch # 75091 Have More Ground Clearance than Factory Hitch 2000 Toyota 4Runner
- Q&A: Cross Reference Chart for Kodiak Trailer Disk Brake Pads to Automotive Applications
- Article: Trailer Wiring Diagrams
- Q&A: Troubleshooting No Power on a Tekonsha Voyager Brake Controller
- Q&A: Troubleshooting a Tekonsha Voyager Brake Controller No Green Light and Full Power all the Time
- Article: Rooftop Cargo Carriers
- Article: Gooseneck to 5th Wheel Adapters