Cable Length for the Switch for Part Number BD1824200100
Question:
What is the cable length/ wires on the BD1824200100 kit
asked by: Wade F
0
Expert Reply:
The wires that come out of the switch housing (gray box) on the Bulldog Powered-Drive Kit for Single-Speed Jacks part # BD1824200100 are 72" in length. The wires that come out of the motor are 16".
I've included a video of the installation we did here at etrailer to give you an idea.
expert reply by:
Randy B
0
Product Page this Question was Asked From
Bulldog Powered-Drive Kit for Single-Speed Jacks w/ 12,000-lb Capacity
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Motor and Gear Parts
- Powered-Drive Kit
- Bulldog
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: How Much Slack Is Needed In Trailer Wire Connection To The Tow Vehicle?
- Q&A: Replacement Trailer Grease Seals for Allis 5013 29772
- Q&A: Replacement Trailer Hub/Drum for Part Number 2420801
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: Kit to Convert 2021 Vanleigh Pinecrest 335RLP to Electric Over Hydraulic Disc Brakes
- Q&A: How To Charge 12v Batteries Wired in Parallel
- Q&A: What are the Dimensions of a #99 Spindle
- Q&A: Troubleshooting 2017 Toyota Tacoma Sending Power Only to Trailer Right Side Tail Lights
- Article: Trailer Wiring Diagrams
- Article: Trailer Hitch Receiver Sizes
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: How to Choose the Right Trailer Hitch Class
- Article: Stability Control for Heavy Duty Vehicles
- Article: Replacing RV Awning Fabric: Your Step-by-Step DIY Guide