Replacement Fender for Performance No Longer Trailer with 20.5 x 8.0-10 Tire Size
Question:
I need to replace a galvanized fender from a Performance no longer boat trailer. It fits over a 20.5 x 8.0-10 tire and in between two welded steps that are part of galvanized trailer where fenders bolts to. I measure just under 22.5” between steps which I assume is fender length. I also measure 9’’ fro frame to outside of wheel which I assume is fender width. Can you help recommend a replacement gala sized or plastic fender? Thank you,
asked by: Dave I
Helpful Expert Reply:
I attached a picture that shows the dimensions of the Single Axle Trailer Fender part # J10821 that you referenced which shows it's very similar to what you have now. This would work well for you since the dimensions are so similar.
Product Page this Question was Asked From
Single Axle Trailer Fender - Jeep Style - 16 Gauge Steel - 10" Wheels - Qty 1
- Trailer Fenders
- No Step
- 10 Inch Wheels
- 10 Inch Wide
- 20 Inch Long
- Steel
- Weld-On
- For Single-Axle Trailers
- Silver
- Redline
more information >
Continue Researching
- Article: Trailer Tire Sizing
- Q&A: 2008 4 Runner Sport Rhino Rack Roof Rack Options
- Article: Trailer Lighting Requirements
- Q&A: Trailer Fenders for 33 Inch BFGoodrich Mud Tires
- Q&A: Troubleshooting Rear Lippert Ground Control 3.0 Jacks Not Retracting
- Article: Where to Position the Trailer Axle?
- Article: How (and Where) to Connect an RV Propane Grill
- Q&A: How To Determine Bearings and Seals For Older Long Chih Trailer
- Q&A: Location of Brake Controller Plug 2019 Jeep Cherokee Limited
- Q&A: Distance from the Midpoint of Curve to the Bottom of the Legs of a etrailer Trailer Fender # HP76VR
- Q&A: What is the Height of the Lip on Jeep-Style, Single-Axle Trailer Fender HP76VR
- Article: Trailer Wiring Diagrams
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Towing a Trailer? Let's Talk About Brake Controllers