What is Diameter of Mounting Holes of Polar Door Hinge PLR2008-SSP
Question:
Bolt size or hole size for tamper proof bolt? Can the stainless tamper proof barrel nut and bolt be purchaseh on etrailer? Thasnkss,
asked by: Daran
1
Helpful Expert Reply:
All of the mounting holes of the Polar Door Hinge part # PLR2008-SSP are 5/16 of inch. We don't have tamper proof hardware in this size but locally or elsewhere online you should be able to track it down pretty easily.
I attached a review video link for this for you to check out as well.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
T-Strap Hinge w Wide Bracket for Enclosed Trailers - 7-5/8" Long - 180 Degree - Stainless Steel
- Trailer Door Hinges
- Strap Hinge
- Wide Bracket
- Stainless Steel
- 7-5/8 Inch Long
- 2 Inch Wide
- Bolt-On - Pre-Drilled Holes
- Polar Hardware
more information >
Continue Researching
- Q&A: What Bolts Are Needed For Installing T-Strap Hinge # PLR2008-SSP on a Trailer?
- Q&A: Three Hinges To Hold Large SST Door 10 Foot Tall By 6 Foot Wide And Approximately 800 lbs
- Q&A: How To Find Correct Replacement Door Hinge for Enclosed Trailer
- Q&A: Distance Between Holes on T-Strap Hinge # PLR3408
- Q&A: Changing a Trailer Ramp Door To Barn Doors On A 6x14 V-Nose Enclosed Trailer
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Q&A: Dimensions of Square Corner Hinge with Reverse Bracket PLR2212-SSP
- Q&A: A/C Unit Recommendation for my Enclosed Trailer With Heat Strip
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: Trailer Wiring Diagrams