What Size Screw Does the Replacement Endcap for Westin Sure-Grip Running Boards Use
Question:
WHAT TYPE AND SIZE SCREW ARE NEEDED TO ANCHORE THE END CAP? ARE THE MOUNTING HOLES IN THE RUNNING BOARD TO HOLD THE ENDCAP INPLACE?
asked by: GEORGE H
0
Expert Reply:
The Replacement Endcap for Westin Sure-Grip Running Boards # 80-0221 are held in place with a #8-18x.50" phillips head screw. We do not carry this screw but you can obtain this from any local hardware store. You will want to line up the holes in the running boards with the brass fittings on the end cap and then attach with the sourced screws mentioned above.
expert reply by:
Erik B
0
Product Page this Question was Asked From
Replacement Endcap for Westin Sure-Grip Running Boards - Front Driver or Rear Passenger - Qty 1
- Accessories and Parts
- Nerf Bars - Running Boards
- End Caps
- Westin
more information >
Continue Researching
- Q&A: Measurements of Stake Pocket Tie-Down Anchor for Flatbed Truck or Trailer # T35Z or # T355
- Q&A: Where is the Stake Pocket Tie-Down Anchors # PK-SPTD Manufactured?
- Q&A: Dimensions Of The Replacement Endcap For Westin Sure-Grip Running Boards
- Q&A: Running Boards and Light Kit For 2012 Toyota 4Runner Limited
- Q&A: Width & Length of Westin Gap Strip for Westin Sure-Grip Running Boards, Part # 27-9907
- Q&A: Recommended Running Boards To Replace Narrow OEM Steps On 2020 Toyota 4Runner