Roller Bunk Recommendation for a 17 Foot Ranger Jet Boat and King Salt Water Boat Trailer
Question:
I need to be able to push my boat off of the trailer in some cases. The shallow water available will not allow me to lower my boat enough for it to float off. I have a 17foot ranger jet boat alluminum with a 90 hp honda motor. My trailer is a King salt water single axle trailer. Its main supports are just over 6foot apart and currently are 2X6 felt covered lying flat. These boards are approximately 8foot long. How could I utilize rollers to allow me to push my boat off in these rare instances. My current weight will not allow me to manually push my boat back enough for the boat to tilt into the water. Big fish but need to get to them!
asked by: Bill
Expert Reply:
The easiest solution, if possible, is to back the trailer further into the water. If that is not an option, rollers could help you and definitely make it easier to launch the boat and pull it back on the trailer. For rollers, given that your bunks are flat and about 8 feet long, I would go with 2 sets of # DL21740. Each piece is 4 feet long and they can be mounted directly to the bunks. Each set of rollers has a 2,500 pound capacity.
Products Referenced in This Question
Boat Trailer Deluxe Roller Bunk - 4' Long - 10 Sets of 3 Rollers - by Dutton-Lainson
- Boat Trailer Parts
- Bunks
- Rollers
- Roller Bunk
- Black Rubber
- Dutton-Lainson
more information >
Product Page this Question was Asked From
Boat Trailer Standard Roller Bunks - 5' Long - 12 Sets of 2 Rollers - by Dutton-Lainson
- Boat Trailer Parts
- Bunks
- Rollers
- Roller Bunk
- Black Rubber
- Dutton-Lainson
more information >
Continue Researching
- Article: Boat Trailer Showdown: Bunks vs. Rollers
- Q&A: Can I Use Different Grease w/ the CE Smith Trailer Idler Hub Assembly?
- Q&A: What Size Bolts to Use to Install Dutton Lainson Roller Bunks
- Q&A: How Far Should Rollers Install Behind Rear of Trailer Frame
- Q&A: Overall Height Measurement From Top of Roller to Bottom of U Channel on DL21741 Roller Bunk
- Q&A: Torque Settings For Wheel Lug Nuts For Boat Trailer And utility Trailer
- Article: Best Boat Trailer Jacks
- Q&A: Roller Bunks Rated for More Than 1,500 lbs
- Q&A: Size of U-Bolt Slots in Dutton-Lainson # DL21742 Roller Bunk Bracket for Roller Bunks DL21740/41
- Article: Boat Trailer Guides: Which are the Best?
- Article: Trailer Wiring Diagrams
- Article: RV Cell Boosters, How Do They Work?
- Article: How Much Does a Boat and Trailer Weigh?
- Article: How to Measure for Trailer Hitch Drop