Can Erickson 01805 Tie Down Be Used With Longer Rope
Question:
Is there a problem with replacing the rope? I am afraid if I pull the rope out I will not be able to it back in again.
asked by: Jerome F
0
Expert Reply:
You can indeed replace the 1/2 inch rope with a longer length if you wish, but keep in mind that doing so could change the weight bearing capacity of the tie down. A short length of 10 or 12 gauge wire could be taped to the end of the rope and used to fish the new rope around the pulley and pull it through.
expert reply by:
Mike L
0
Product Page this Question was Asked From
Erickson Tie-Down Rope w/ Ratchet - 1/2" x 12' - 500 lbs
- Ratchet Straps
- Trailer
- Truck Bed
- S-Hooks
- 1 Strap
- Manual
- 11 - 20 Feet Long
- 1-1/8 - 2 Inch Wide
- 351 - 500 lbs
- Erickson
more information >
Continue Researching
- Q&A: Parts Needed to Flat Tow a 2020 Ford F-350 Behind a 2023 Renegade Verona Super C
- Q&A: Parts Needed to Flat Tow a 2023 Ford F-250
- Q&A: Does 2022 Ford F-350 Super Duty Demco Classic Base Plate Kit Fit with Lower Front Air Dam
- Q&A: Weight Capacity of Demco Base Plates for a 2020 Ford F-350
- Q&A: Replacement Propane Gas Detector for an Atwood 31013 Propane Detector
- Q&A: Pros and Cons of Running Two Inflation Valves or One in Air Bag Suspension Kit on Vehicle
- Q&A: Can Ultra-Fab Electric A-Frame Jack Pull Power From Tow Vehicle
- Article: RV and Camper Types, RV Classes
- Article: How to Measure for Trailer Hitch Drop
- Article: Most Popular Wheel Bearings
- Article: Trailer Wiring Diagrams
- Article: Best Bike Racks for Electric Bikes
- Article: Adding Electric Over Hydraulic Disc Brakes
- Article: Trailer Maintenance Schedule