Will the Replacement Center Flat Kit Work With a Western MVP Plow With a Back Blade
Question:
Does this part fit on a western mvp vnose with a back blade edge installed?
asked by: Bob M
1
Helpful Expert Reply:
I was able to reach out to my snow plow guy over at Buyer's Products/SAM and he confirmed that the Replacement Center Flap Kit with Hardware for Fisher/Western Snowplow # 3371304410 is a fit for Western MVP v-nose plows. Since the carriage bolts in the spaces where you'll be mounting this center flap are usually a bit longer than the rest of the bolts on the plow, you will be able to mount this with or without a back blade edge.
expert reply by:
Erik B
1
Product Page this Question was Asked From
Replacement Center Cutting Edge Kit for Fisher EZ-V and Western MVP V-Plow Snow Plows
- Snow Plow Parts
- Fisher Plow Parts
- Western Plow Parts
- Cutting Edge Parts
- Mounting Brackets
- SAM
more information >
Continue Researching
- Q&A: Trailer Connector on 2008 Chevy Silverado 1500 not Working Properly
- Q&A: Troubleshooting Trailer Wiring on 2008 Chevy Silverado 1500
- Q&A: Installing the Replacement Back Drag onto a Fisher Snow Plow
- Q&A: How to Replace Ventline Vent Lid # BVD0449-A01 on a Ventadome Trailer Vent
- Q&A: Trailer Brakes Not Working Properly After Replacing Brakes and Drum
- Q&A: Torque Specs for 3500-lb 5-on-4-1/2 Dexter Hub/Drum 84546UC3
- Article: Adapters for Towing a 5th Wheel Trailer with a Gooseneck Hitch
- Q&A: Can I Use the Gen-Y Shock Absorbing 5th Wheel to Gooseneck Pin Box