Will K Source Rearview Mirror # KSRM011 Fit Over a 2007 Cadillac Factory Mirror with OnStar
Question:
We have a 2007 Cadillac and are wondering if this mikrror would work with all the electronics in the mirror.....phone, On star, etc.
asked by: Elaine R
Expert Reply:
The buttons for mirrors with features like OnStar are usually housed below the glass portion of the factory rearview mirror. Because they are lower than the glass portion, it is possible that adding the K Source mirror, # KSRM011, can be completed without blocking the buttons on the factory mirror.
You will need to measure to determine if the buttons will be blocked if adding this mirror. The overall height of the mirror is 3-3/8 inches. Find the very center of your factory mirror (not the center of the glass but the center of the whole mirror including the housing) and measure down 1-3/16 inches. From that point measure to the left or right 9 inches (in the direction of the buttons).
This is the approximate area the bottom edge of the mirror will be once installed. When measuring, if you find the buttons will not be obstructed, it will fit.
Another way to determine fit is to cut out a piece of paper or card board that is a 3-3/8 x 18 inch rectangle. Center the cut out piece on the factory mirror to get a good approximation of where the mirror will be relative to the factory mirror.
Product Page this Question was Asked From
K-Source Extra Long and Wide Panoramic Rearview Mirror
- Rear View Mirrors
- Convex Mirror
- Clamp-On
- Panoramic View
- 18 Inch Long
- No Day/Night Switch
- No Added Features
- K Source
more information >
Continue Researching
- Shop: K-Source Extra Long and Wide Panoramic Rearview Mirror
- Article: Best Bike Racks for Electric Bikes
- Article: What is a Gooseneck?
- Q&A: Will a CIPA Rear-View Mirror # CM32000 Fit a 2004 Volvo C70 Convertible
- Q&A: Replacement Cap for RAM Electric A-Frame Trailer Jack
- Q&A: Battery Disconnect for Dual Battery Setup on Diesel Truck
- Q&A: Winch Mounting Plate Needed for Aluma 82 Series Car Hauler Trailer
- Q&A: Replacement Fan Motor For An Everchill Refrigerator
- Q&A: How to Mount Existing 7-Way Connector on New Curt Hitch Receiver
- Q&A: Replacement Atwood Gas Detector 36719
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Adapters for Towing a 5th Wheel Trailer with a Gooseneck Hitch