Mini Light Bar Mount Buyers Products Comparability with BackRack Headache Rack
Question:
compatible? Is the mini light bar mount compatible with the backrack cab protector?
asked by: Dave P
Expert Reply:
It is possible that the Mini Light Bar Mount for Buyers Products Kabgard Headache Rack part # 33785152 fits the Backrack headache rack. It is designed for the Kabgard headache rack part # 33785104 which has a 1" tall by 2" deep square top cross bar that the mount attaches to with the provided hardware. The Mini Light Bar Mount comes with two sets of bolts. The long bolts are about 3-1/4" long and the shorter bolts are 2-1/4". If you measure the top cross bar of the Backrack and its fits these dimensions then you won't have any issues using the Mini Light Bar mount. I have attached a photo of how it attaches.
Products Referenced in This Question
Buyers Products Kabgard Headache Rack - Black Powder Coated Steel
- Headache Rack
- Bar-Style Headache Rack
- No-Drill Application
- Steel
- Without Lights
- With Load Stops
- Black
- Buyers Products
more information >
Product Page this Question was Asked From
Mini Light Bar Mount for Buyers Products Kabgard Headache Rack
- Accessories and Parts
- Headache Rack
- Light Brackets
- Buyers Products
more information >
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Grease Seal Fit based on Inner Diameter and Outer Diameter
- Q&A: Replacement 25" Slipper Spring Needed for 3,500 lb Axle
- Q&A: Inner Depth of Lippert Components Clear Oil Cap Kit # LC693935
- Q&A: Grease Caps For Hubs on Lippert 7,000 lb Axles
- Article: 2023 Best Gifts for Boaters & Fishing Enthusiasts
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: Best Air Bag Suspension (2023)
- Q&A: Recommended Adjustable Ball Mount With 2" and 2-5/16" Hitch Ball That Is Made In The USA
- Q&A: Recommended Ball Mount with Drop for Towing and Receiver for Other Accessory
- Q&A: Hub and Drum Assembly for AL-KO T-52 Axle
Andrew
5/12/2020
I am looking to mount this on a tractor with a roll over bar that is 2x2, will this fit?