Can 3 inch Pipe Mount of Bulldog Swivel Jack Attach to 2 inch Trailer Frame
Question:
Is it possible to use BD190758 Bulldog jack with BD015279 2” male weld on jack pipe mount? The jack specified that it ships with a 3” female weld-on mount. Wondering if reversing the gender is ok because I only have 2” frame to weld to.
asked by: Sean
Expert Reply:
Even though you have a 2 inch tall frame to weld a pipe mount to the 3 inch pipe mount that comes with the Bulldog Jack # BD190758 will still attach securely enough to it. You'll just need to have it welded around the mount where it touches the frame and you'll be fine. Your 2 inch pipe mount should still match up to this as a male fitting but the 3 inch mount would be better.
Product Page this Question was Asked From
Bulldog Square Swivel Jack w/ Round Pipe Mount - Drop Leg - Sidewind - 28-1/2" Lift - 5,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 4001 - 5000 lbs
- Sidewind Jack
- Swivel Jack
- 15 Inch Lift
- Pipe Mount
- Weld-On
- With Rectangle Foot
- Bulldog
more information >
Continue Researching
- Q&A: Inner and Outer Diameters of Pipe Mount Piece for Bulldog Square Swivel Jack w/ Round Pipe Mount
- Q&A: What are the Measurements on a Bulldog Square Swivel Jack # BD190758
- Q&A: How To Determine Axle Rating Of Dexter Torsion Axles
- Article: Stability Control for Heavy Duty Vehicles
- Q&A: Is there a Ball Mount Larger than a Class V 2-1/2 Inch
- Q&A: Determining The Correct Capacity Winch For A 10,000lb Boat
- Q&A: Tallest Available Pipe Mount Swivel Trailer Jack
- Q&A: Retracted Height Dimension of the Bulldog Jack part # BD190708
- Article: How to Choose the Best Winch for You, your Boat, and your Trailer
- Article: Best Boat Accessories
- Article: Trailer Jacks
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Trailer Tire Sizing
- Article: The 5 Best Trailer Drop Hitches You Can Buy