Troubleshooting Pilot Brake Controller 80550 That Only Shows Max Voltage of .3
Question:
2012 f650. Replaced old controller for a digital readout pilot. Got it connected and went to test it and it only goes from 0 to 0.3, even when the knob is maxed out. What are we missing? Thanks
asked by: SHAWN N
0
Expert Reply:
Typically when the Pilot brake controller part # 80550 only shows the super low amperage that you mentioned the issue is that the power and ground wires were wired backwards and the controller would need to be replaced. The white wire should run to ground and the black to 12 volt power.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Pro Series Pilot Trailer Brake Controller - 1 to 3 Axles - Time Delayed
- Trailer Brake Controller
- Time Delayed Controller
- Electric
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 3 Axles
- Digital Display
- Up to 360 Degrees
- Pro Series
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Replacement For TDE LP75 Disc Brake Actuator
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Weight Capacity and How Dexter DX7.5L Brake Actuator Installs on Trailer Frame
- Q&A: Can I Weld on a Bolt on Brake Actuator?
- Article: How to Choose the Right Trailer Hitch Class
- Article: Brake Controller Installation: Starting from Scratch
- Article: Enjoy The 2024 Eclipse With Harvest Hosts
- Q&A: Replacement Options for Apollo AAC24BIB with Furrion RV Microwave 13.5K watt/0.9 Cu Ft.
- Q&A: Replacement Trailer Grease Seals for Allis 5013 29772
- Q&A: Parts Needed to Install the Prodigy P3 Brake Controller on a 2024 Honda Pilot
- Q&A: What Is Needed To Safely Flat Tow A 2023 Chevy Silverado 1500
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: The 5 Best Trailer Drop Hitches You Can Buy