Could Drop Leg # JF-1005H-Z Fit Trailer Jack BAL 29025
Question:
It appears this leg foot has a good chance of fitting the tongue jack on my 2019 Viking 17FQS, which I believe is a BAL Model 29025 tongue jack. Can you confirm this? Thanks!
asked by: John
0
Expert Reply:
I looked up the BAL 29025 jack you have on your trailer and it's not very similar to the jack the Drop Leg part # JF-1005H-Z so I can't say it looks like an easy fit confirmation but if you check out the attached dimensional picture for this leg you'll be able to compare it to your jack to see if would fit. The only dimension not in the picture is the pin diameter for the leg which is 3/8 inch.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Drop Leg for etrailer and Ram Jacks - 13-1/4" Tall - 5-1/4" Diameter Footplate - Zinc
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Legs
- Drop Leg
- etrailer
more information >
Continue Researching
- Article: Trailer Maintenance Schedule
- Article: Trailer Wiring Diagrams
- Article: RV Electrical Power Systems
- Article: How to Charge RV Batteries
- Q&A: Dexter Axle Hub Conversion for 14.5 Inch or 15 Inch Wheels on Equipment Trailer
- Q&A: Recommended Flat Towing System for 2017 Ford Explorer FWD with 3.5L
- Q&A: Is 3/4" Wide Butyl Tape Wide Enough For The MaxxFan MA00-07000K?
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: 2023 Best Gifts for Haulers & Towers
- Q&A: Trailer Break Control Installation for Tekonsha Prodigy P3 on 2019 Mercedes-Benz Sprinter 3500
- Q&A: Where is the Trailer Brake Controller Plug on a 2020 Mercedes-Benz Metris
- Q&A: Replacement Microwave for my High Pointe EC942K9E in Stainless
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Can The Converter In A Progressive Dynamics # PD4135K Power Center Be Disabled