Lippert 6 Point Ground Control System Monitor is Blank But System is Still Working

Question:

The display on my Lippert 6 point system won’t show anything on the instruction panel, despite going thru all the manual troubleshooting instructions..The front jacks will go up and down to engage and disengage the truck, plus it will level the trailer when we push auto level. Are we in danger of the whole system stopping to work and leaving us high and dry, if we don’t replace the module ? The only thing wrong is the display won’t advise what is happening . It does the normal been when the fifth wheel is level.

asked by: Fred W

Expert Reply:

It sounds like the display for the system may just need to be reset; we've seen this reported before and if you can unplug it, let it sit for a few minutes and then plug it back in- it might solve your problem. We've seen just doing that alone fix most of the problems with the control panels. Since everything else is working, it sounds like the display may just be the issue.

If you've already followed this step and that doesn't solve your issue you might want to consider replacing the panel with the # LC421484 , but it looks like the only thing not working is the actual display on the Control Panel, which isn't going to stop the system from working. So you won't have to worry about being left high and dry as long as the controls are still working correctly.

Please let me know if this didn't work for you and I can also look for some other troubleshooting solutions that might be helpful.

expert reply by: Erik B