Process for Painting Polar Flush Hinge # PLR104SS
Question:
I would like to paint these hinges black. What process would be needed?
asked by: Charles D
0
Expert Reply:
The Polar Flush Hinge # PLR104SS is made from stainless steel which is a very easily paintable surface. If you lightly sand it and apply a stainless steel primer to it an oil based paint would look great and be very durable.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Strap Hinge - 5-1/2" Long x 3-1/4" Wide - Stainless Steel
- Trailer Door Hinges
- Strap Hinge
- Flush Hinge
- Stainless Steel
- 5-1/2 Inch Long
- 3-1/4 Inch Wide
- Bolt-On - Pre-Drilled Holes
- Polar Hardware
more information >
Continue Researching
- Article: Trailer Tire Sizing
- Q&A: What Should Tire Pressure be for a Load Range G 110 psi Tire
- Q&A: Recommended RV Exterior Ladder for 22 Ft Thor Four Winds RV
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Replacement Brake Assemblies and Hub/Drums for 15k Dexter Axle
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Weight of 21K Demco Hijacker AutoSlide 5th Wheel Hitch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: How Far Back Should Thule Mounting Feet Be Placed On a 2019 Toyota Highlander with Bare Roof
- Q&A: When Flat Towing a Vehicle How Much Tongue Weight is on the Trailer Hitch
- Article: How to Replace or Install an RV Roof Vent
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Article: Replacement Automotive Lighting
- Article: The Differences Between Cam Buckles and Ratchet Straps (And Who Would Win In a Fight)