Horsepower Increase of Edge Programmer Installed on 2006 Ford F-250 Powerstroke
Question:
I have a 2006 Ford F-250 6.0L diesel Powerstroke. I have a cold air intake upgraded turbo, and 4 inch magnaflow exhaust. I was wondering how much horsepower and torque would increase with this
asked by: Matt
Expert Reply:
The Edge CS2 programmer part # EP85301 is normally good for up to 80 additional horsepower and 200 ft lbs of torque on a totally stock vehicle. With basic bolt ons the power increase is hard to specify exactly but typically the bolt modifications work great with the programmers and you gain right at the same power on top of the power increase of the bolt ons.
Now you did say you have a upgraded turbo which if the turbo is a different size than what your truck came with you'd need to look into fuel upgrades as well as a custom tune which this programmer does not provide. If it's the same size turbo then you'd be fine.
Product Page this Question was Asked From
Edge Diesel Evolution CS2 Performance Tuner - Color Screen - CA Approved
- Performance Chip
- Performance Tuners
- Tuner Only
- Color Screen
- Yes - California Approved
- Evolution
- Edge
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Performance Chips and Modules
- Q&A: Replacement Follower Leg for a Venture VMC900L Landing Gear Set
- Q&A: Maximum Towing Capacity of 2004 GMC Sierra 2500HD SLE 4x4 Crew Cab 6 Foot Bed
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps