How To Wire the Replacement Control Module for Lippert Electric Coach Steps LC301702
Question:
I have connected the smale Green wire to the frame and the purple to the light stair. But the long Green vhere do you connect this one?
asked by: Jules
0
Expert Reply:
In regards to the Replacement Control Module for Lippert Electric Coach Steps part # LC301702, the long light green wire with a ring terminal on the end will go to a ground point on the chassis. The short dark green wire with ring terminal on the end should be grounded to the step frame. Therefore, one is a ground for the chassis and the other a ground for the step frame. I have attached a wiring diagram of said control module for you as well.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Replacement Control Module for Lippert Electric Coach Step
- Accessories and Parts
- RV Steps
- Control Module
- Lippert
more information >
Continue Researching
- Q&A: Troubleshooting Controller Module for Kwikee Steps
- Shop: Replacement Control Unit for Kwikee Electric RV Steps
- Q&A: Replacement Trailer Wheel for Dexstar Wheel 17-293
- Article: Replacement Automotive Lighting
- Q&A: Replacement Brake Assemblies and Hub/Drums for 15k Dexter Axle
- Q&A: How Many Transfer Switches are Needed to Switch from Shore Power to a Genreator, and An Inverter?
- Article: Trailer Tire Sizing
- Q&A: Replacement for SCS/Frigette Coach Step Controller Part 202-3230
- Q&A: Wiring Diagram for Coach Step
- Q&A: Replacement Parts and Wiring Diagram for Lippert Coach Steps
- Article: Gooseneck Trailer Hitch Information and Review
- Article: Trailer Wiring Diagrams
- Article: The Definitive, Step-by-Step Flat Towing Setup Guide
- Article: Flat Towing Package for 2005-2007 Jeep Liberty
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)