Troubleshooting Bevel Gear Pin Not Budging
Question:
vertical bevel gear pin will not come out . I have heated it with a propane torch let it cool, hit it with a punch and it will not move
asked by: Frank S
1
Helpful Expert Reply:
If you've already tried heating up the pin and hitting it with a punch then the only other thing I can think of for the Lead Jack Repair Kit # LG-146059 is to spray it with some lubricant like WD40 in case there is any corrosion and then hit it harder with the punch. There unfortunately isn't any kind of special trick so it really boils down to who is more stubborn - you or the pin.
expert reply by:
Jon G
1
Product Page this Question was Asked From
Lead Jack Repair Kit for Stromberg Carlson Landing Gear
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Hardware
- Repair Kit
- Stromberg Carlson
more information >
Continue Researching
- Q&A: Replacement gears for Lippert Landing Gear Instructions and Diagram
- Article: Trailer Tire Sizing
- Article: How to Measure for Motorhome Steps
- Q&A: Venture Bevel Gear Kit Instructions
- Q&A: Landing Gear Repair Kit for Venure VMC900L Follow Leg
- Q&A: Replacement Landing Gear Legs for Set with Number VMC900R
- Q&A: Useable Length Of Replacement Rail Pins For 5th Wheel Trailer Hitch
- Q&A: Replacement Parts or Assembly for Landing Gear of 1998 Gulfstream Innsbrook
- Q&A: Replacing ADTH 1RV-200 Landing Gear Motor
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Trailer Wiring Diagrams
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)