How to Remove Bearing Buddy Bearing Protector From Hub
Question:
I tried removing the bearing Buddy by tapping with a wood block just like the first three but this one separated leaving the insert still in the hub and the grease part came off. Is there a different way to get these out? These were brand new. I thought they were all one piece.
asked by: Gary I
Helpful Expert Reply:
The best way to remove a Bearing Buddy Bearing Protector like # BB2717 is pretty much what you've been doing. Because the fit inside the hub bore is pretty tight, you just have to take a rubber mallet (or wood block) and firmly tap it around the sides until it's unseated and loosened up enough to pull it out by hand. This process is briefly shown right at the beginning of the video I attached below.
If your Bearing Buddy came out in a couple of pieces it was likely damaged in the removal process. The unit should indeed be one single piece (not counting the rubber cover). When removing one just make sure you aren't hitting the unit too hard (but firm enough) and are alternating the contact point between each hit (left side, right side, top, etc).
Product Page this Question was Asked From
Bearing Buddy Bearing Protectors - Model 2717 - Chrome Plated (Pair)
- Trailer Bearings Races Seals Caps
- Caps
- Bearing Protector Grease Cap
- 2.717 Inch
- Bearing Buddy
more information >
Continue Researching
- Search Results: rod buckle
- Article: How to Tie Down a Motorcycle
- Search Results: spare mount for trailers
- Search Results: lug nut wrench
- Search Results: trailer alarm
- Search Results: lug wrench
- Video: Kenda Tires and Wheels - Tire with Wheel - AM30580 Review
- Video: Kenda Tires and Wheels - Tire with Wheel - AM30740 Review
- Video: Kenda Tires and Wheels - Tire with Wheel - AM30820 Review
- Shop: Kenda Loadstar 5.30-12 Bias Trailer Tire with 12" White Wheel - 5 on 4-1/2 - Load Range C
- Shop: Kenda 5.30-12 Bias Trailer Tire with 12" White Wheel - 5 on 4-1/2 - Load Range B
- Shop: 4-Way Lug Wrench - 20" Long - SAE and Metric
- Shop: Kenda 4.80-12 Bias Trailer Tire with 12" White Wheel - 5 on 4-1/2 - Load Range B
- Shop: Flint Hill Goods Spare Tire Mount - 3" x 5" - 4 and 5 Lug Wheels
- Q&A: How to Remove Bearing Buddy Trailer Bearing Protectors
- Shop: Bearing Buddy Bearing Protectors - Model 1980A w/ Auto Check - Chrome Plated (Pair)
- Shop: Spare Tire Cover
- Video: Optronics License Plates and Frames LP15SB Review
- Video: Cleaning and Replacing Hubs and Bearings
- Q&A: Motorcycle Trailer Tire Air Pressure Required
- Q&A: Recommended PSI for Size 5.30-12 Tires
- Q&A: Correct Tire Pressure for 5.30x12 Trailer Tires
- Q&A: Trailer Tire Recommendation for a Motorcycle Trailer with 5.30-12
- Search Results: grease fitting
- Search Results: axle buddy
- Q&A: Bearing Buddy Bearing Protectors Keep Falling Off Trailer at Highway Speed
- Shop: Trailer License Plate Mount Bracket, Angled, Rust Proof Polymer - Black
- Q&A: How Does Inner Bearing Get Grease When using Bearing Buddy
- Shop: Trailer Wiring
- Article: Most Popular Wheel Bearings