Having Difficulty Moving Enclosed Motorcycle Trailer with Trailer Valet Trailer Dolly
Question:
Hello. I purchased the STC-V211 a few months back to use on my 7x12 enclosed motorcycle trailer. I was wondering if I had to unload my 2 motorcycles before using the dolly. I tried to use it with the trailer loaded on dry, flat, smooth pavement and it wouldnt turn the trailer at all. If I tried to use it in a straight line it would work somewhat, but if I turned the handle the crank would not even budge it. Im pretty sure the tires were up to pressure. Im wondering if it was too much weight for it to handle. Thanks
asked by: Gordon F
Expert Reply:
The Trailer Valet # STC-V211 can handle trailers with up to 500 lbs of tongue weight, if you're under that amount you should be okay as far as weight goes. Whats most likely is that you are using the wrong gear. Try putting the crank on the upper driveshaft and see how that works. This is a pretty common occurrence.
If you find out that your tongue weight is close to or over the 500 lb figure, try moving some of the load toward the rear of the trailer if possible. Lightening the trailer's tongue weight will make it easier to transport.
Product Page this Question was Asked From
Trailer Valet 5X Swivel Jack and Trailer Mover - Topwind - 15" Lift - 5,000 lbs
- Trailer Dolly
- Manual Dolly
- 5000 lbs Capacity
- 15 Inch Tall
- Steel
- Silver
- Trailer Valet
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Trailer Valet 5X Swivel Jack and Trailer Mover - Topwind - 15" Lift - 5,000 lbs
- Search Results: trailer mover
- Shop: Replacement Lid for Camco RV Polyethylene Propane Tank Covers - Black
- Shop: Trailer Valet XL Trailer Dolly with Chain Drive - 2" Hitch Ball - 10,000 lbs
- Shop: Rack'Em Trailer Dolly
- Search Results: trailer dolly
- Q&A: Where Does Safety Bolt of Trailer Valet 5x Install
- Shop: Replacement Motor for Kwikee Revolution Series Electric RV Steps - 12V
- Shop: Replacement Lid for Camco RV Polyethylene Propane Tank Cover - Black
- Shop: Furrion Replacement Connector for RV Power Cord - Male - 30 Amp
- Shop: RV Plug Adapters
- Video: Trailer Valet 5X Swivel Jack and Trailer Mover Review
- Search Results: trailer valet
- Q&A: Should 30 Amp Breaker be Used When Installing Installation Kit For Trailer Brake Controller
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Trailer Hitch
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Shop: Trailer Wiring
- Q&A: Can The Removable Bumper Panel Be Used After Draw-Tite Receiver Is Installed on 23 Grand Cherokee?
- Search Results: trailer valet xl
- Shop: Brake Controller
- Video: Trailer Valet RVR5 Remote-Controlled Trailer Dolly Review
- Article: Trailer Wiring Diagrams
- Q&A: Trailer Hitch Recommendation for 2024 Jeep Grand Cherokee
- Q&A: Comparing Curt And Draw-Tite Trailer Hitches For A 2024 Jeep Grand Cherokee
- Video: Trailer Valet Tandem Axle Trailers Wheel Dolly Review
- Shop: Suspension Enhancement
- Article: How to Measure for Trailer Hitch Drop
- Video: Curt Class III Trailer Hitch Installation - 2023 Jeep Grand Cherokee L
- Shop: Roof Rack