Are Mounting Holes of Replacement Electric RV Stabilizer Jack Motor # LC352338 Threaded
Question:
Thanks for your reply Jameson but you did not give the tapped hole thread size. Can you give me that?
asked by: Edward E
1
Helpful Expert Reply:
Yes, I attached a picture of the motor part # LC352338 and you can see that the mounting holes are threaded.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Replacement Electric RV Stabilizer Jack Motor for Lippert Landing Gear
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Motor and Gear Parts
- Motor
- Lippert
more information >
Continue Researching
- Shop: Fifth Wheel Hitch
- Shop: Replacement Electric RV Stabilizer Jack Motor for Lippert Landing Gear
- Shop: Replacement Handle for Bladex and Valterra Waste Valves - Threaded - Plastic - Black
- Shop: Extension Rod for LaSalle Bristol Waste Valve - 12" Long
- Shop: Replacement Handle for Bladex and Valterra Waste Valves - Threaded - Plastic - Gray
- Shop: Replacement Handle for Bladex and Valterra Waste Valves - Metal
- Shop: Extension Rod for LaSalle Bristol Waste Valve - 36" Long
- Shop: Valterra Waste Valve Extension Tube with Handle - 8"
- Search Results: rvk2604
- Video: SoftStartRV RV AC Unit Soft Start Install - Fifth Wheel
- Video: SoftStartRV RV AC Unit Soft Start Review
- Search Results: 138445
- Q&A: Will Demco Recon for Recessed Ball Fit Gooseneck Ball with 1" Platform
- Q&A: Will a 5th Wheel to Gooseneck Adapter Work With Cushioned Pin Box
- Q&A: Troubleshooting A Demco Recon Gooseneck-to-5th Wheel Hitch Adapter
- Q&A: Does SoftStartRV for AC Units Work with Dometic 13.5k BTU AC Unit
- Search Results: rp21501
- Search Results: ma86jr
- Search Results: lc285318
- Search Results: valve handle
- Search Results: lp gas detector
- Q&A: Replacement Slide Out Motor For 2010 Gulfstream Sport Lite
- Q&A: Availability of Replacement Trailer Wheel Center Caps
- Q&A: Replacement Motor For Stabilizers On a 2010 Keystone Sprinter 34FT RV Camper
Edward B.
9/17/2019
Thanks for your reply Jameson but you did not give the tapped hole thread size. Can you give me that?