Can The BoatBuckle Fishing Rod Holder Be Cut Down To Size
Question:
These look great However my Jon boat where I need to mount them is not this wide Can I cut in half and have 2 mounts and be able to mount each half of each side? Thoughts? Thanks
asked by: David H
0
Expert Reply:
It is possible to cut down the BoatBuckle Vertical Rod Hold-Down PLUS System part # IMF15435 to fit the space that you want to mount them in but the strap that holds the rods into the foam piece will not be able to properly fasten so I do not recommend it. The foam piece of the holder measures 11 inches long by 2 inches wide.
expert reply by:
Heather A
0
Product Page this Question was Asked From
BoatBuckle Vertical Rod Hold-Down PLUS System - 8 Rods with Reels - Deck or Gunwale Mount
- Fishing Rod Holders
- Tie Downs
- Deck Mount
- Gunwale Mount
- Polyester
- 8 Rods
- Black
- BoatBuckle
more information >
Continue Researching
- Q&A: Replacement Idler Hub For Old Boat Trailer With DICO 45264 Idler Hubs
- Q&A: Replacement Parts and Winch for a Profile 2000 Hand Winch
- Q&A: Replacement Bearings and Seal for Freedom Axle 45264 Hub Assembly
- Q&A: Will the CE Smith Roller-Style Guide-Ons Fit an EZ Loader Boat Trailer with 4 Inch Tall Frame
- Q&A: What is the Angle of the CE Smith Roller-Style Guide-Ons for Boat Trailers
- Q&A: Replacement Hub for DICO 45264
- Q&A: Recommended Replacement Hand Winch for a Profile 2000
- Article: Trailer Wiring Diagrams
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: My Trailer Hitch Doesn't Fit
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Determining Trailer Tongue Weight
- Article: What is Boondocking
- Article: 2023 Best Gifts for Boaters & Fishing Enthusiasts