Can EZ Lube Spindles Over Fill Trailer Hub And Cause Issues
Question:
lm wondering why these caps arent more common. ls there a reason they can be detrimental? l imagine over filling could be a concern.
asked by: Will G
Helpful Expert Reply:
You are exactly correct, it is very easy to overfill trailer hubs with grease using EZ lube spindles but they still can be helpful if used carefully. The issue though is that not all spindles have the zerk fitting to allow you to pump grease in them which is why caps like the # RG04-040 aren't on all hubs.
I still recommend people pack their bearings by hand as that ensures you get all of the old grease out, new grease in, and you won't have to worry as much about blowing grease seals due to overfilling.
Product Page this Question was Asked From
Grease Cap, 1.99" OD EZ Lube Drive in with Plug - Qty 2
- Trailer Bearings Races Seals Caps
- Caps
- E-Z Lube Grease Cap
- 1.99 Inch O.D.
- TruRyde
more information >
Continue Researching
- Shop: Grease Cap, 1.99" OD EZ Lube Drive in with Plug - Qty 2
- Shop: Kodiak Disc Brakes - 10" Hub/Rotor - 5 on 4-1/2 - Dacromet/KodaGuard - 3,500 lbs - E-Z Lube
- Shop: Easy Grease Trailer Idler Hub Assembly for 3.5K Axles - 5 on 4-1/2 - Pre-Greased
- Shop: Easy Grease Trailer Idler Hub Assembly for 3.5K Axles - 5 on 4-1/2 - Galvanized
- Shop: Kodiak Trailer Hub for 3,500-lb Axles - 5 on 4-1/2 - Galvanized Steel
- Shop: Kodiak Disc Brake Kit - 10" Rotor - 5 on 4-1/2 - Dacromet and KodaGuard - 3,500 lbs
- Q&A: Grease Seal for Spindle that is 1.68 Inches in Diameter
- Q&A: What is Difference Between Bearing # 168255TB and # 171255TB
- Q&A: Troubleshooting Water Getting Inside Hub on a 2019 Karavan Trailer For Boston Whaler 17 Montauk
- Video: Kodiak E-Z Lube Disc Brakes Installation
- Video: etrailer Trailer Idler Hub Assembly Installation
- Video: TruRyde Trailer Bearings Races Seals Caps - Caps - DC250L-DCRP Review
- Search Results: marine brakes
- Search Results: grease cap tool
- Search Results: hub and bearings
- Search Results: bearing buddy
- Search Results: idler hub
- Search Results: master cylinder
- Q&A: Would Too Much Grease in a Trailer Hub Cause the Grease Caps to Fall Off
- Q&A: Does The Bearing Buddy Protect the Bearing from Water
- Q&A: Could Zerk Fitting be Added to Trailer Spindle to Make it an EZ Lube Spindle
- Shop: Double Lip Seal for 3,700-lb Marine Hubs
- Q&A: Does Lubed Dust Cap and Rubber Plug # DC250L-DCRP Have a Zerk Fitting to Add Grease
- Search Results: dexter axle grease caps
- Video: Demco Hydraulic Brake Actuator Reverse Lockout Solenoid Review
- Video: TruRyde Trailer Bearings Races Seals Caps - Bearings - BK1-150 Review