Cross-Shaft For Landing Gear Turns But Leg Does Not Extend/Retract
Question:
unit works fine electricly 1 leg will not move the bar that turns the jack is turning the generator blocks that jack any ideas thanks
asked by: Ken M
0
Expert Reply:
It sounds like you are saying the cross-shaft is spinning but one of the legs is not extending/retracting. If that is the case then it sounds like you have a stripped gear in that leg. In order to fix this you can use the Follow Jack Repair Kit part # LG-146060 or the Lead Jack Repair Kit part # LG-146059 depending on which leg is not extending/retracting.
expert reply by:
Conner L
0
Products Referenced in This Question
Lead Jack Repair Kit for Stromberg Carlson Landing Gear
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Hardware
- Repair Kit
- Stromberg Carlson
more information >
Product Page this Question was Asked From
Follow Jack Repair Kit for Stromberg Carlson Landing Gear
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Hardware
- Repair Kit
- Stromberg Carlson
more information >
Continue Researching
- Q&A: Venture Bevel Gear Kit Instructions
- Article: Trailer Wiring Diagrams
- Q&A: Follow Jack Repair Kit for 2010 Coachmen Brookstone 341RE
- Q&A: Do the Colors of Trailer Brake Magnets Mean Anything
- Q&A: Useable Length Of Replacement Rail Pins For 5th Wheel Trailer Hitch
- Q&A: How to Wire 12V Battery in Enclosed Trailer to Power Trailer Lights Independent of 7-Way Connection
- Q&A: Installing a Battery on a Trailer and Wiring it to Run Interior Trailer Lights
- Q&A: Landing Gear Repair Kit Recommendation for a VMC900R Set
- Article: Best Ladder Racks
- Article: How Much Solar Power Do I Need For My RV?
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: How to Tie Down a Motorcycle
- Article: 7 Common Questions Everyone Has About Trailer Tires