What Pin Does Brake Output Circuit of Trailer Attach to On Junction Box 38656
Question:
Where does that terminal connect? The video makes mention of it but doesnt address it further
asked by: Jeffrey M
0
Expert Reply:
The terminal labeled "stop" is the correct one to connect the brake output circuit of your trailer wiring to. This would be the one fourth from the left. I attached a picture that shows all of the terminal labelled for you to check out as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Continue Researching
- Video: Spectro Trailer Wiring Junction Box Installation
- Q&A: Wiring Functions for Hopkins 7-Way Trailer Side Connector
- Shop: Trailer Wiring Junction Box
- Shop: Ring Terminal - 12-10 Gauge Wire - 3/16" Ring ID
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Adding a Battery on an Enclosed Trailer to Power Interior Lights
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Q&A: Is There A Picture Of This KE33JR So I Can See Exactly What It Looks Like
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Recommended Parts to Rewire an Old Trailer w/ Brakes
- Q&A: Do You Cut Tabs on Both Stacked SeeLevel Sensors SE88VR
- Q&A: Dimensions for Buyers Product Wiring Junction Box # 3375601101
- Q&A: How to Establish Ground Connection When Re-Wiring Aluminum Trailer
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)