Do I Need To Sync My Air Lift WirelessONE After Removing the Battery
Question:
I changed the batteries in my remote and now it doesn’t light up or work. Does this remote need to be sync to the compressor again? Or do I need a new replacement remote. Also when the remote stopped working the airbags would automatically fill full I would have to manually release the air. Thanks,
asked by: Jeff
Expert Reply:
The Air Lift WirelessONE Compressor Remote part # AL72704 for the Air Lift WirelessONE Compressor System AL25870 would only need to be re-synced if the battery was out for more than 15 minutes or if you replaced the remote. Assuming you have the battery installed correctly, I would say the remote is bad and needs replaced. I have attached this re-syncing process for you below. The auto fill is most likely caused by a leak in your system.
1. Turn ignition on.
2. Locate the sync wire in the wire harness. It will be the yellow wire that is looped with a yellow cap around it.
3. Remove the yellow wire from the cap leaving the cap attached to the harness.
4. Disconnect power to the receiver. Unplug the connector on the top.
5. Connect power to the receiver while grounding the sync input.
6. Listen for 3 clicks of the internal solenoid, then one click every second. This will indicate that you are now in the “sync mode”. Sync mode will last for 30 seconds total. Within the 30 seconds press any button on the transmitter to send a message to the receiver. Once the receiver has received a message it will sync with that transmitter and stop clicking the solenoid in 1 second intervals.
7. Reinsert the yellow wire terminal into the molded cap.
Product Page this Question was Asked From
Replacement Remote for Air Lift WirelessONE Compressor System for Air Helper Springs
- Accessories and Parts
- Air Suspension Compressor Kit
- Vehicle Suspension
- Remote Control
- Air Lift
more information >
Continue Researching
- Q&A: Dimensions of the Buyers Products Hitch Plate for Chevy/GMC
- Q&A: Dimensions of Buyers Products Hitch Plate with Receiver Tube 1809065
- Q&A: How To Replace Battery On Remote For Air Lift WirelessONE Compressor System # AL72704
- Q&A: Will Curt Echo Wireless Trailer Brake Controller 90250 Work on Motor Home with 7-Way
- Q&A: Troubleshooting Remote Not Working When Batteries Were Replaced
- Q&A: Troubleshooting Air Lift WirelessONE Remote Not Working
- Q&A: How To Pair an Air Lift WirelessAIR Remote to Compressor
- Article: Stability Control for Heavy Duty Vehicles
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Must-Have Flat Towing Components
- Article: Using a Portable Generator on RV
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: How to Install E-Track in 3 Easy Steps
- Article: Replacement Automotive Lighting