Could Depth of Valterra A/C Vent Grille # A10-3348VP Get Reduced with Hack Saw
Question:
I would like to install this vent on a 3/4inch depth board. Would it be possible to use a hack say to cut the plastic to reduce the depth to 3?4inch without damaging the operation?
asked by: Mel P
0
Expert Reply:
You could easily reduce the depth of the Valterra A/C Vent Grille # A10-3348VP that you referenced down what you mentioned and it would still install and function well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Valterra RV Ceiling Vent w/ Covered Screws - Rotating - 4" Diameter - Black
- RV Vents and Fans
- Vent
- Ceiling Vent
- Wall Vent
- No Fan
- 5-1/2 Inch Diameter
- Plastic
- Black
- Valterra
more information >
Continue Researching
- Article: Tire TLC: How & When to Check Your RV/Trailer Tire Pressure
- Q&A: King Pin Locks Compatible With PullRite Superglide Capture Plates
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: Troubleshooting Curt Echo App Giving Low Battery Voltage Warning
- Q&A: What is the MasterLock King Pin Lock Made From and How Much Does It Weigh
- Q&A: Differences Between MaxxAir 2 and MaxxAir Standard Vent Covers
- Q&A: Replacement RV Step Motor for Part Number 300-1406
- Article: How (and Where) to Connect an RV Propane Grill
- Q&A: Recommended King Pin Lock For a 5TH Wheel Caming Trailer
- Q&A: Recommended Weight Distribution for 5000 lb GVWR Toy Hauler
- Article: Where to Position the Trailer Axle?
- Article: Calculating Portable Generator Power Needs
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Article: Best Air Bag Suspension (2023)