Install Video Guide to Use for Install of Torklift GlowSteps

Question

Question:

TorkLift GlowStep Revolution Scissor Steps w/ Landing Gear - 3 Steps - 27-1/2inch Base - 375 lbs Item # TLA8003 Hi guys, 2 questions: 1. We need installation specs and guide before ordering.

asked by: Philippe J

0

Expert Reply:

The Torklift Glow Steps part # TLA8003 install just like a standard set of RV steps. While I don't have a link to install instructions I can send you I did attach a link to an install video that will walk you through the process which will be much more helpful!

expert reply by: Jameson C

0

Answer 1

As you have identified, the entry height of the TorkLift GlowStep Revolution Scissor Steps w/ Landing Gear, #TLA8003 for three steps, and #TLA8004 for four steps, overlap in their application specs. The #TLA8003 is for entry height of 25-1/2" -…

view full answer...

Answer 2

The Torklift #TLA8003 (3 Steps) will fit for your trailer. These are intended for a mounting bracket measuring 27-1/2" and an entry height of 25-1/2" to 36". Alternatively, the Torklift #TLA8004 (4 Steps) is designed for an entry…

view full answer...

Answer 3

Each one of the steps of the TorkLift GlowStep Revolution Scissor Steps #TLA8003 that you referenced is 8 inches deep and there are three of the steps so it would stick out a total of 24 inches give or take a few inches. The reason I say "give…

view full answer...

Answer 4

Yes, TorkLift GlowStep Revolution Scissor Steps Item #TLA8003 is the correct steps for the measurements you provided to replace the steps on your 2016 Keystone Cougar Fifth Wheel. I do recommend, if you have pets, to add the SafeStep Vinyl Barrier…

view full answer...

Answer 5

The correct TorkLift GlowStep Revolution Scissor Steps for a 2017 Keystone Premier 30RIPR is part #TLA8003 according to TorkLift. That said, you could use the TorkLift GlowStep Revolution Scissor Steps part #TLA8004 so long as your entry height is…

view full answer...

Answer 6

The closest thing we offer to what you said you are looking for is the TorkLift GlowStep Revolution Scissor Steps #TLA8104. The tops step will be within a few inches of the top portion of the bracket for the steps. I attached a picture of what the…

view full answer...

Answer 7

Based on the information you have given me, you have a 3,500 lb axle that is 84" long (hub face to hub face) with a 70" spring center length. At this time we do not have any replacement axles that are 84" long, but I do have a…

view full answer...

Answer 8

The replacement antenna for the Voyager WiSight Wireless RV Backup Camera Monitor #WVOM541AP is part #VO54FR on our site. If you're looking for the replacement antenna for the camera #WVCMS130AP instead then that would be part #PXXHD0006301R that…

view full answer...

Answer 9

I checked directly with BOLT for you, and they confirmed for me that your 2021 Chevy Silverado is absolutely compatible with their trailer hitch locks. Take a look at the accompanying photo, and if you have the same center cut key, the correct lock…

view full answer...

Answer 10

The Bolt hitch lock part #BL7023582 that you referenced does fit your 2014 GMC Sierra 1500. I attached a chart that has all of the vehicle this works with. I also attached a link to a review video for this lock for you to check out as well.

view full answer...

Answer 11

The Dexter 10K electric brakes #23-439 (right side) and #23-438 (left side) will have to be manually adjusted using the adjustment wheel below the magnet. To adjust the brakes you will use a small screwdriver or similar tool to turn the adjustment…

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Install Video Guide to Use for Install of Torklift GlowSteps

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching